Origin	China
Model Number	RF008T
Brand Name	Heinkel

RF-008T is formulated chemical product with a proprietary activator, a very active, low solids content, no clean flux with a small additon percentage or resin that enhanced thermal stability, while maintaining a high level of long-term electrical reliability.This special characteristic is good for copper and soldering layer surface wetting effect. After wave soldering, RF-008T leaves a low level of non-tacky residue, which is easily penetrable in pin testing.

FEATURES & BENEFITS  

 *Highly active for excellent soldering and low defect rates.                                      *Low level of non-tacky residue to reduce interference with pin testing.  *Cleaning is not required which reduces operating costs.   *Reduces the surface tension between solder mask and solder to significantly reduce solder  ball frequency.                                                                                        *Meets Bellcore requirements for long-term electrical reliability.   

For more technical details, please visit http://www.solderingrosinfluxcore.com

APPLICATION GUIDELINES      RF-008T is formulated chemical product to be applied by foam, wave or spray methods.The rosin flux spraying layer density and its evenness is the success key of its application. Recommend spraying layer density from 500 to 1500 mirco gram per square inch in order to maintain consistent soldering performance and electrical reliability. More important, it is to begin the process with circuit boards and components that meet established requirements for solderability and ionic cleanliness.The heating temperature is the key factor of all elements such as the conveyor speed, component or circuit board etc. During the wave soldering, the  top side circuit board preheated temperature is 190 - 240F (88-115C) and the bottom side board preheated temperature is 250 - 325F (121 - 163C).  

HEALTH & SAFETY                                                                                                                          Inhalation of the flux solvent and volitalized a activator fumes which are generated at soldering temperatures may cause headaches,dizziness and nausea.Suitable fume extraction equipment should be used to remove the flux from the work area.  An exhaust at the exit end of the wave soldering machine may also needed to completely capture the fumes. Soserve precautions during handling and use. Suitable protective clothing should be worn to prevent the material from coming in contact with skin and eyes.

RF-008 flux contains a highly flammable chemical solvent with a flashpoint 56F (13C). The flux must not be used near open flames or near non-flameproof electrical equipment.